How To Repair A Pool Table

How to Repair a Pool Table

by

Greg Dennely

The smallest flaw on a pool table surface can cause quite a bit of aggravation. There isn’t anything more disappointing to the skilled pool player than making a perfect shot and seeing the movement of the ball be displaced by a small tear or hole in the surface area of the cloth.

Before your friends, neighbors, or patrons begin tearing their hair out, know that you can easily take care of this. Patching the cloth will not work; you are going to have to resurface the entire table! Don’t be concerned, this is a fairly simple one man job that’s not too expensive. The felt cloth can be found on line, from a billiards supply store, and even at some fabric stores. The billiard supply stores will have championship quality felt. This cloth is available in a variety of different colors and is usually bought by the square yard. The billiard supply store will be able to tell you precisely how many square yards you should have, so you must bring your measurements with you. Because of the drop on the sides for the bumpers and the fact you will be stretching the cloth and attaching under the rails, add at least 12 inches on each side of the surface dimensions. The next step is to remove the old cloth. This should be fairly easy and how it is attached will depend on the table backing. Wood backed tables use staples and slate tables most commonly are glued. Remove the side rails and place your new felt across the table stretching it lengthwise. If you are resurfacing a wood backing begin stapling the felt under the rails in the middle first on one side. Place a staple about every 4 inches. When you reach a corner, stop and go to the next corner. Stretch the felt tight and begin stapling the opposite side. Make sure the surface is smooth. If you have a slate backed table you will need a good spray adhesive. Spray the adhesive on the table about five inches from the edge of the table. Spray some more adhesive on the underside of the cloth. Wait about a minute for the glue to become tacky and press the felt down. Follow the same procedure as with the staples, doing one side first and then the opposite side. After you have the sides finished and the table completely covered over, use a razor blade tool to make little holes where the rails bolt down onto the table. This will prevent the bolts from causing tears that could travel when you fasten down the rails. Cut from the backside of the felt. Pull back the pocket lining which is sometimes leather for example, and pull the felt down at the pockets and glue or staple. Then cover with the pocket lining and reattach for a finished job. As it’s really quite difficult to move pool tables around, most repairs are usually made on location. When you resurface your table yourself, you have saved several hundred dollars over a house call. Slate Repair. You might find a need to make repairs to slate seams and cracks in your pool table. A great time to do this is while the felt is off when you are recovering the table. Billiard beeswax is a special wax that contains resin and hardens more than normal beeswax. This wax dries very hard and yet has enough flexibility to move with the table. Using a small torch, melt the wax and let it drip into the seam or crack. Use a paint scraper or putty knife to remove any excess wax. For larger cracks a slate patch is necessary.

I found it incredibly easy to pinpoint local businesses that specialised in

pool table repairs

at Home Services Engine. This site is clearly laid out and I found the local business I was looking for right away, so if you’re looking for a great local pool table repair shop, go to=>

homeservicesengine.com/pool_table_repairs/

Article Source:

How to Repair a Pool Table